Parameter assignment of a Mobile Client
4.6 General settings
Mobile Client900RXA
Operating Instructions, 07/2015, A5E36360099-AA
67
Procedure
1.
Enter the number of minutes after which the screen saver is to be activated.
The minimum setting is 1 minute and the maximum setting is 360 minutes. Entering "0"
disables the screen saver.
2.
Select the type of screen saver:
–
Use the "Standard" option to enable the Windows CE default screen saver.
–
Using the option "Standard with Dim Backlight" you activate the Windows CE standard
screen saver and reduce the backlight to a value between 25% and 90%.
If you enter a value outside the range of 25 to 90%, a message will appear and the
value is reset to 25%.
–
Use the "Blank Screen" option to enable an empty screen as the screen saver.
3.
Using the option "Dim Backlight to" you reduce the backlight to a value between 25% and
90%, without activating a screen saver.
If you enter a value outside the range of 25 to 90%, a message will appear and the value
is reset to 25%.
4.
If you want to allow deactivation of the screen saver by increasing the display brightness,
select the check box "Allow manual dim …".
Increasing the display brightness immediately deactivates the screen saver.
5.
If you want to delay touch operation, select the check box "Protect against operation"
An operating element cannot be operated until at least 500 milliseconds after activation
of the screen saver.
6.
Confirm your inputs.
The dialog closes.
The screen saver for the HMI device has now been set. You will need to restart the HMI
device after the screen saver has been activated. The screen saver is then enabled.
4.6.5
Configuring transfer
A project can only be transferred from the configuration PC to the HMI device when at least
one data channel is configured and enabled on the HMI device. Follow the procedure below
to configure transfer mode.
If you block all data channels, the HMI device is protected against unintentional overwriting
of the project data and HMI device image.
Requirement
You have opened the "General" tab in the "Transfer Settings" dialog with the "Transfer" icon.
