Installation and connection
4.2 Mounting the charging station
Mobile Panel 277F IWLAN
66
Operating Instructions, 12/2007, A5E01003940-01
4.2
Mounting the charging station
Requirements
● 4 x M6 cylinder head screws, with nuts if required
● You have selected a location with a low ambient temperature
To charge the batteries, the ambient temperature / battery temperature must not exceed
40 °C
● You have selected a position for the charging station that is easy and safe to reach
● You have selected a good ergonomic height for the charging station
Procedure
Proceed as follows:
1.
Place the charging station from the front onto the mounting surface.
2.
Mark the fastening holes with a marking-off tool.
3.
Drill 4 through holes or 4 x M6 threaded holes.
4.
Mount the charging station.
Result
The charging station is now mounted.
See also
Mounting location and clearance of charging station (Page 54)
Application and ambient conditions (Page 51)
4.3
Setting transponder ID and inserting the battery
Introduction
To operate the transponder you must first insert the batteries and set the transponder ID.
The transponder ID is read and evaluated by the HMI device in the current project.
Requirements
● Torx screwdriver, size T10
● Screwdriver, size 0
● 3 AA mignon batteries, 1.5 V, included in delivery
