BA 5230 en 04/2011
7.3.1.3 Interiorpreservation procedure
•
Stop the gear unit.
•
Drain the oil into a suitable container (see section 10, "Maintenance and Repair").
•
Unscrew the air filter including the reducing screw.
•
Pour in the preservative agent through the hole in the reducing screw up to the upper mark on the
oillevel indicator.
For preservative agent agent, see table 3 or 4 in item 4.4.1!
•
Screw in the air filter including reducing screw.
•
Start the gear unit and allow it to idle briefly.
•
Unscrew the oildrain plug or open the oildrain cock.
•
Drain the preservative agent into a suitable container.
•
Dispose of the preservative agent in accordance with the regulations.
There is a risk of scalding from the hot preservative agent draining from the gear unit.
Wear protective gloves!
•
Screw in the oildrain plug or reclose the oildrain cock.
•
Replace the air filter with the screw plug.
Before restarting the gear unit, replace the screw plug with the air filter. Observe the
instructions in item 7.1.1.
7.3.2
Exterior preservation
7.3.2.1 Exteriorpreservation procedure
•
Clean the surfaces.
For separation between the sealing lip of the shaftsealing ring and the preservative agent, the
shaft should be brushed with grease in way of the sealing lip.
•
Apply preservative agent.
For preservative agent, see table 5 in item 4.4.2!
