Siemens DW03500 pureFlow, Instructions For Use Manual, Page: 38 / 202

36
en
Child protection
The user must start dispensing within 4 seconds
after pressing the selection button (Hot water).
Otherwise, for reasons of safety, the appliance
switches automatically into the function “Cold
water”.
The appliance is equipped with a child protection
system so that children can not be scalded by hot
water.
If the child protection system is activated, hot water
can not be dispensed.
To activate or deactivate the child protection sys-
tem, proceed as follows:
Press and hold the push-button
■
for at least
3 seconds.
The child protection LED (25a) lights up and indi-
cates that this is activated.
To deactivate, press and hold the push-button
■
again for at least 3 seconds.
The child protection LED switches off. Hot water can
be dispensed once again.
Saving energy
Location
Selecting the right location is important in terms of
energy consumption.
Erect the appliance in a dry, ventilated room.
■
Do not place in direct sunlight or in the vicinity
■
of a heating source (e.g. radiator, oven).
Light sensor
The light sensor (19) measures the daylight and
automatically reduces energy consumption when it
is dark by decreasing the frequency of heating and
cooling cycles. This function can be switched on
and off.
LED Cold water
Light sensor swiched on
(energy-saving)
Light sensor swiched off
Press and hold the selection buttons
■
(Cold
water) and (Hot water) simultaneously for at
least 3 seconds to switch into SET mode.
One of the hot water LEDs briefly lights up and a
signal tone is emitted.
Now, the light sensor can be switched on and
■
off by pressing the selection button (Cold
water).
To save the setting, press and hold the selection
■
button (Ambient) for at least three seconds.
All LEDs light up two-times. The setting has been
saved.