1.2 Safety Notes
EN-4 SINAMICS V60 Controlled Power Module (CPM60.1) Getting Started
Only qualified personnel should be allowed to work on this drive system, and only after
becoming acquainted with all the safety notices regarding installing, connecting,
commissioning, operation and maintenance as set out in this manual. Failure to observe
these notices contained in this manual can result in death, severe personal injury or
considerable damage to property. Without prior authorization, you are not allowed to
perform any modification on the drive.
Deliverables received must be complete and intact. Exercise caution to ensure that you do
not put a damaged device into service. Make sure that the drive, the motor and the cables
received correspond with the specific drive package you ordered from Siemens.
Transport and storage must meet specified environmental conditions.
Do not handle the motor by gripping the connecting cable (motor cable, brake cable or
encoder cable) or the motor shaft.
Risk of fire or electric shock. Use caution to ensure that you do not install the drive and the
motor in an area which is subject to inflammables or combustibles, water or corrosion
hazards.
Do install the drive in a distribution cabinet with an adequate protection level.
Do not install the drive and the motor in a location where it is likely to be exposed to constant
vibrations or physical shocks.
Risk of fire. Make sure that no any foreign body (such as chips of wood or metal, dust, paper
scraps, etc.) falls into the drive or lies on its heatsink.
Keep sufficient clearance between drives, one drive and another device/inner wall of the
cabinet.
Siemens recommends that you tighten the screw on the terminal door of the drive, after you
have completed the installation work.
General
Identification
Transport & Storage
Mechanical installation
WARNING
WARNING
WARNING
CAUTION
CAUTION
NOTICE
