Preface
CP 154xSP-1
4
Operating Instructions, 12/2019, C79000-G8976-C426-05
Directly below, you will find the firmware version of the CP as it shipped.
The MAC address of the interface is printed on the front at the bottom left, above the
connectors for the power supply:
●
00:1B:1B:xx:xx:01 (interface)
You can learn the MAC addresses of the ports via the online functions of STEP 7 (assessible
devices):
●
00:1B:1B:xx:xx:02 (port X1P1)
●
00:1B:1B:xx:xx:03 (port X1P2)
Product names, terms and abbreviations/acronyms
Below you will find abbreviations and product names used often in this manual.
●
CP / module / device
When properties listed in this manual are valid for all three types of CP, these names are
used in place of the complete product names of all three types of CP.
If information is only valid for specific types of CP, the respective CP names are listed in
the text or in the section header.
New in this edition
●
New firmware version V2.1, with the following functions among others:
–
Support of additional SDTs for OUC blocks
–
Greater number of configurable data points (telecontrol), see Configuration limits and
performance data (Page 24).
–
Direct communication of the CP 1542SP-1 IRC between (DNP3 / IEC 60870-5)
●
Description of the functions of firmware version V2.0:
–
Connection to SINEMA Remote Connect (CP 1542SP-1 IRC / CP 1543SP-1)
–
Configured e-mail independent of telecontrol communication (CP 1542SP-1 IRC /
CP 1543SP-1)
–
Support of the telecontrol protocol SINAUT ST7 (CP 1542SP-1 IRC)
–
Time synchronization via time of day of the communications partner
(CP 1542SP-1 IRC)
Released CPUs for CP firmware V2.0: CPUs as of firmware V2.0
Functions configurable in: STEP 7 Professional as of V15
●
New ATEX/IECEx approval
●
New structure of the documentation
The documentation for the CP consists of these operating instructions and additional
configuration manuals for the CP 1542SP-1 IRC, see below.
