IV319 Rev.00
Data 2010-06-22
Pag. 19 di 118
Indicates the operating mode of the UPS in
graphics mode. The will be displayed when
the mains power is normal; The will be
displayed when the UPS is working in bypass
mode; The
will be displayed when the UPS
is working in battery mode; The will be
displayed when the inverter is working normal.
Indicates the UPS is working in fault mode.
Indicates some warnings occur which need be
attention.
UPS setting Information
One of these four values of the output nominal
voltage could be selected, it can be modify only
when the UPS is in No output or Bypass mode.
One of these two nominal frequency values of the
output voltage could be selected, it can be modify
only when the UPS is in No output or Bypass
mode.
Bypass disable or enable could be selected, it can
be modify only when the UPS is in No output or
Bypass mode.
* Notes:
For 3/1 10K UPS, only the information of phase T will be shown;
while for 3/1 15K & 20K UPS, only the information of phase R will
be shown.
Summary of Contents for Green Point 6 20KVA
Page 28: ...IV319 Rev 00 Data 2010 06 22 Pag 28 di 118 Wiring diagram of 6K 10K 1 1 parallel system...
Page 29: ...IV319 Rev 00 Data 2010 06 22 Pag 29 di 118 Wiring diagram of 10K 3 1 parallel system...
Page 57: ...IV319 Rev 00 Data 2010 06 22 Pag 57 di 118 DB 9 Interface of AS400 communication protocol...
Page 61: ...IV319 Rev 00 Data 2010 06 22 Pag 61 di 118 Back View of 15K 20K 3 1...