Siel Green Point 6 20KVA, User Manual

Page: 42 / 61

IV319 Rev.00
Data 2010-06-22
Pag. 42 di 118
9. Trouble Shooting
Problem
Possible cause Solution
The Fault code is
³
08
´
, and the
buzzer beeps
continuously.
The UPS transfers to
fault mode due to
internal overheat.
Make sure the UPS is not
overloaded; the air vents are not
blocked and the ambient
temperature is not too high. Wait
for 10 minutes for the UPS to
cool down before turning on
again. If failed, please contact the
distributor or service center.
The Fault code is
³
09
´
, and the
buzzer beeps
continuously.
The UPS output is
short circuited.
Remove all the loads. Turn off the
UPS. Ensure that the load is not
failed or the UPS has no internal
faults before turning it on again. If
failed, please contact the
distributor or service center.
The Fault code is
³
05
´
or
³
06
´
, the
UPS beeps
continuously.
The UPS transfers to
fault mode due to its
internal fault.
Please contact the distributor or
service center.
The UPS turn into
Battery mode.
The voltage or
frequency of the utility
power is out of the
input range of the
UPS.
The UPS is running in Battery
mode. To save your data and
close the application program.
Make sure the utility power is
within the input voltage or
frequency range permitted by the
UPS.
The Fault code is
³
07
´
, the UPS
beeps continuously.
The UPS is
overloaded or the
load equipment is
faulty.
Check the loads and remove all
no-critical equipment.
Recalculate the load power and
reduce the number of loads
connected to the UPS. Check
that the loads are not failed.
The Warning code
is
³
23
´
, the buzzer
beeps every
second.
The charger of the
UPS is defective. Please contact the distributor or
service center.