4.3
Mounting the device
Important notes
NOTE
For an application with single-deep and double-deep rack storage, first align the device
to the single deep rack. Then, if necessary, adjust the position of the device for the
double deep rack.
NOTE
InspectorP631: The optics are already pre-focused at a distance that is suitable for
most applications. It is rarely necessary to adjust the focus position,
.
Procedure
1.
Install the device to the mechanics with the bracket so that the device points
vertically to the positioning mark on the rack. Do not angle the device relative to
the surface.
2.
Connect the device to the interfaces and supply voltage.
✓
The
Continuous measurement
parameter is enabled by default. The device starts in
measurement mode.
3.
To switch the laser alignment aid on and off, press the
pushbutton on the
device. The laser alignment aid helps align the device.
✓
The device projects two red laser points on the rack. The laser points indicate
the viewing direction of the camera. The center of the image is between the two
points.
4.
Align the device so that the positioning mark on the rack is between the two laser
points and is therefore in the center of the image.
Figure 4: Example installation
4
MOUNTING
16
O P E R A T I N G I N S T R U C T I O N S | InspectorP Rack Fine Positioning
8024534/1DQ8/2022-01-14 | SICK
Subject to change without notice
