Operating instructions
Chapter
10
ICR 84x Image Code Reader
Appendix
8 010 961/0000/10-05-2005
©
SICK AG · Division Auto Ident · Germany · All rights reserved
10-37
For bar codes only!
Entering bar codes using a handheld scanner with integrated decoder
1.
Connect the handheld scanner with decoder to the auxiliary interface of the ICR (via
CDB 420 or CDM 420). For the pin assignment, see
Chapter 5.3 “Pin assignments“,
.
2.
Set the data format and communication parameters on the handheld scanner as shown
in
.
3.
Read the code with the handheld scanner.
The ICR sends immediately the data received from the PC to the host via the host
interface, independent of an active reading pulse.
If you connect a SICK Hand-held Scanner from the IT 38xx/46xx/48xx/58xx series, set the
communication parameters and data output (data and terminator) as shown in
10.7.3
Connection to Profibus DP
See
“CMF 400-1001 Field Bus Gateway for Profibus DP“ Operating Instructions
(no. 8 010 462, English version)
10.7.4
Connection to DeviceNet
See
“CMF 400-2101 Field Bus Gateway for DeviceNet“ Operating Instructions
(order no. 8 010 464, English version)
10.7.5
Building up a CAN scanner network
See
“Application of the CAN interface“ Operating Instructions
(order no. 8 009 180, English version)
Parameter
Value
Data transmission rate
9,600 bd
Data bits
8
Parity
No
Stop bits
1
Data interface
RS 232
Prefix (Header)
Clear all Prefixes
Suffix (Terminator)
CR
Table 10-5: Communication parameter settings for the SICK Hand-held Scanner from the
I
T 38xx/46xx/48xx/58xx series