Brown
Blue
Gray
White
Green - Data 1
Yellow - Data 0
Red - 12V
Black - GND
Induced surge will travel both way via
cable to damage device at end point.
CABLE TRAVELING INSIDE PIPING
(Subject to lightning surge induction)
Signal
Power
Dual Technology RFID
ACTIVE DIRECTIONAL READER
M
AG
INSIDE GUARD HOUSE
(Safely protected by surge protector at end point.
All surge protector MUST be connect to EARTH.)
TPLAN
Data surge
protector
PD12/7.5
Data and
DC surge
protector
PSP12
protector
DC surge
Access controller
Data 1
Data 0
GND
Wiegand
port
OUTSIDE NEAR BARRIER GATE
AR500 U
RFID Long Range
12 V
GND
DC Power Supply
12V,3A
Common
GND
M
AG
AR500U Quick User Manual
D131
D132
Auto IR signal adjustment
Manual IR signal adjustment
D131 D132
S1S2 S3 S4
A
B
C D
D127
D136
LED
Description
S1
S3
S2
S4
Reader enable/disable
WG 26/34 mode selection
WORK
VDS and ADD is not used.
Blinking to indicate normal
function
Not used
(A) How to Increase signal strength?
1. Press Button C until LED D132 turn on.
2. Press button D to increase signal strength. There are
8 LEDs to indicate IR strength level (D127 to D136). As
you press button D, you will notice more LED will turn
on to indicate higher signal strength.
Programming
A = Setting selection (S1, S2, S3 or S4)
B = Confirm and exit setting mode
C = IR auto/manual mode
D = IR strength adjustment
D127
D136
Minimum
Maximum
Optimum
(default)
LED to indicate IR signal strength
Button for programming and setting
Not used
Power LED
Read card LED
AD1 - AD5
Reader address 1 to 5
AD1 to AD5
WORK
(C) How to enable/disable card reading?
1. Press button A until S1 blinking
2. Press button B to change LED S1 on/off status
Turn on LED S1 to enable reader
Turn off LED S1 to disable reader
(B) How to change wiegand output format WG26/WG34?
1. Press button A until LED S3 is blinking
2. Press button B to change LED S3 on/off status.
Turn on LED S3 for WG26
Turn off LED S3 for WG34
LED to indicate setting status
(Safely protected by surge protector at end point.
All surge protector MUST be connect to EARTH.)
