Function
Description
5
Parameters for development. This can be used to display the debug region used
for system maintenance.
6
This option supports system maintenance and further development.
NOTE
This option is not required in check mode. Since this option uses up
additional time, it should always be deactivated in inspection mode.
While the edges have not yet been positioned, the teach result for the edges
Edge 1
to
Edge 3
is shown with the symbol
. The edges are positioned on the tabs
Edge1
to
Edge3
.
7.5.5.3.3
Edge1
,
Edge2
and
Edge3
tabs
The
Edge1
,
Edge2
and
Edge3
tabs are used to set the edges for alignment.
To activate the search rectangle for the edge layout of the first edge, click the
Edge1
tab.
The search rectangle is displayed as a filled green rectangle:
NOTE
If the search region is not displayed in the image, the zoom factor may be
too large and the region is outside the display area. Decrease the zoom factor to view
and move the region.
Now resize, position, and orient the rectangle manually or use the numeric input fields
on the tab.
7
OPERATION
52
O P E R A T I N G I N S T R U C T I O N S | FOS-HVS
8027445/V1-0/2022-06-15 | SICK
Subject to change without notice
