Function
Description
1
X value/column value of the midpoint of the ellipse.
Larger values shift the midpoint to the right, smaller values to the left.
2
Y-value/line value of the midpoint of the ellipse.
Larger values shift the midpoint downward, smaller values shift it upward.
3
The angle determines the orientation of the ellipse.
For an angle = 0°, radius 1 changes the width of the ellipse and radius 2
changes the height.
For an angle = 90°, radius 1 changes the height of the ellipse and radius 2
changes the width.
4
Radius along the major semi-axis of the ellipse.
5
Radius along the minor semi-axis of the ellipse.
7.5.7.4
ROI Seal
page
The
ROI Seal
function is used to search for foreign bodies in the area of rubber seals,
sealing beads or other structures that may have slight tolerances when positioned on
the inspection object. The position tolerances are included in the checks.
7.5.7.4.1
Common
tab
The configuration options in the
Common
tab are the same as those described in the
ROI
Circle
7.5.7.4.2
Options
tab
The
Options
tab is used to configure display or maintenance parameters.
Figure 75: ROI Seal, Options tab
Function
Description
1
Show region (enabled by default).
2
Show result region.
3
Show difference region.
4
Show contour deviations along the course of the rubber seal. These “branches”
occur when a foreign object is directly against the rubber seal.
5
Show inner circle. To distinguish the rubber seal from possible foreign objects, a
smallest inner circle on the rubber seal is used to look for outliers.
6
Parameters for development. This can be used to display the debug region used
for system maintenance.
7
OPERATION
72
O P E R A T I N G I N S T R U C T I O N S | FOS-HVS
8027445/V1-0/2022-06-15 | SICK
Subject to change without notice