2x4s: approximately four, 8’ to 10’ lengths per unit.
All-Thread: 3/8” to 1/2”, cut in 1’ lengths, two pieces per
embedded pipe.
Nuts & Washers: to fi t all-thread, four sets per embedded pipe.
Stakes: metal/wood, approximately six per unit.
Pavers/Cinder Blocks: 1 to 2 per unit.
Tie Wire/C-Clamps
Duplex Wood Nails/Dry Wall Screws
Concrete: 3250 psi or better.
Tools: cordless impact driver, skill saw, pliers, hammer, small
sledge, magnetic level, tape measure, shovels, wheelbarrows,
etc.
Plans/Drawings: schematic drawings and instructions for each
model # to be installed.
The following information for contractors, maintenance personnel and supervisory staff will help
ensure an accurate, safe and problem-free installation.
SUGGESTED MATERIALS
Area should be fenced—recommend 6’
temporary fencing, entire perimeter.
Ground should be thoroughly graded and
“fi nished grade” accurately established, using
either laser or string-line methods.
Prior to digging, entire site should be “laid-out”
with all footings clearly marked as per plans.
In the U.S. contact “Dig Alert” for clearance to
dig, and follow all local construction regulations
(fencing, dirt removal, etc.)
Dig footings, closely following given dimensions.
Remove dirt and debris from site, prior to
placing units.
SITE PREP -
Before equipment handling
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
1.
2.
3.
4.
5.
6.
Preliminary Instructions:
In-Ground Embedded Footings
Please be advised that the use of decomposed granite surfacing
(DG) is known to accelerate normal wear & tear of footrests.
