![background image](http://html.mh-extra.com/html/sick/dl1000/dl1000_operating-instructions-manual_1263895063.webp)
8
Reference
8.1
Measurement menu group: Basic settings
8.1.1
Measuring mode
The “Measuring mode” allows the parameter presettings to be activated for two differ‐
ent measuring tasks:
•
Axial object tracking
: used when the measuring object to be detected moves
along the laser beam axis, i.e. if the distance constantly changes, for example, for
object tracking.
•
Lateral object introduction
: used if the measuring object to be detected primarily
moves vertically to the laser beam axis or moves into the laser bean from the side,
i.e. if erratic distance changes are to be detected when the light beam is entered.
Figure 29: "Axial object tracking" and "Lateral entry of the object" measuring tasks
The selected setting results in application-specific pre-selection of the parameters
shown in the following table.
These parameters can be adjusted further for specific measuring tasks in the “Basic”
or “Expert settings.” In such cases, parameter pre-setting is deactivated.
If one of the two parameter pre-settings is activated later, the parameter settings made
are reset to the default values shown in the following table.
Table 29: Parameter values for parameter presettings
Parameter
Axial object tracking
Lateral entry of the object
Measurement cycle time
4 ms
1 ms
Rain and snow filter
3
1
Distance filter
Kalman filter
Averaging filter
Fog filter
On
On
Distance filter depth
-
1
Speed filter depth
10
10
Echo selection
First echo
First echo
Delay time if “no echo”
50 cycles
50 cycles
Mode if “no echo”
Replacement value
Replacement value
Substitute value for “no echo”
distance
6096.000 m
6096.000 m
Substitute value for “no echo”
speed
0 m/s
0 m/s
REFERENCE
8
8024560/1A19/2021-06-30 | SICK
O P E R A T I N G I N S T R U C T I O N S | DT1000 PROFIBUS DP and DL1000 PROFIBUS DP
63
Subject to change without notice