![background image](http://html.mh-extra.com/html/sick/1094452/1094452_manual_1264585119.webp)
Complementary information
In certain cases, you can no longer log into the device with Safety Designer after device
exchange.
5)
If you would like to log into the device, e.g. to change the configuration,
you have to reset the password with help from SICK. The device works with the existing
configuration even without changing the password.
In certain cases (in the event of dust, high air humidity), it may make sense not
to initially disconnect the system plug and the safety laser scanner. In these cases,
proceed as follows:
1.
Disconnect the connecting cables to the system plug.
2.
Unscrew screws from the bracket and remove the defective safety laser scanner
from the bracket.
3.
Move the safety laser scanner with the system plug to a clean location (e.g. office,
maintenance areas).
4.
Unscrew screws in the system plug and remove the system plug from the defective
safety laser scanner.
5.
See above for further steps.
Further topics
•
"Managing passwords", page 107
•
"Version numbers and functional scope", page 131
10.4.2
Completely replacing the safety laser scanner
1.
Disconnect the connecting cables the system plug.
2.
Unscrew the fixing screws and remove the defective safety laser scanner.
3.
Mount the new safety laser scanner,
.
4.
Reconnect the connecting cables to the system plug.
5.
Configure the safety laser scanner,
.
6.
Perform commissioning again, taking particular care to conduct all of the thorough
checks described,
.
10.5
Replacing the system plug
If the system plug is damaged or defective, you must replace it.
NOTICE
Enclosure rating IP65 only applies if the safety laser scanner is closed and the system
plug is mounted.
b
Mount the system plug.
b
Close the M12 plug connector on the safety laser scanner using a male cable
connector or a protective cap.
°
Tightening torque for plug connector: 0.4 Nm … 0.6 Nm.
°
Tightening torque for protective caps: 0.6 Nm … 0.7 Nm.
b
When mounting the connecting cable, ensure the seals are intact and seated
correctly.
NOTICE
If the system plug is mounted with excessive force, the contacts can break or bend.
b
Plug in the system plug carefully.
b
Do not force it.
5)
This case can only occur if you replace a device with old rights management with a device with new rights management or vice versa.
Devices with newer functional scope use the new rights management.
MAINTENANCE
10
8023152/1G5N/2022-06-28 | SICK
O P E R A T I N G I N S T R U C T I O N S | outdoorScan3 Core I/O
119
Subject to change without notice