RN200 user manual 21
no way related to the functioning of the controller, and to view them on the display. It can also
group them (with any criteria), displaying them on one of the three available pages.
The subdivision of the measurements on the different pages is done through the function
configured in the analogue inputs:
AIF.2001: page M.08.
AIF.2003: page M.09.
AIF.2005: page M.10.
The controller shows one measurement per line: it shows the text configured for the analogue
input (P.4002 for analogue input 1), followed by the measurement. If more than 9
measurements are associated with one of these pages, the controller shows them all, rotating
them on the display every two seconds: press and hold the
ESC/SHIFT
button to stop the
rotation on the current display.
This mode displays all the information relating to the management of the inverters for the
renewable sources. The different pages can be scrolled using the horizontal navigation buttons
◄ and ►.
It shows the status of the communication to the configured inverters. It uses one display line
for each inverter. If more than 8 inverters are configured, the controller shows them all, rotating
them on the display every two seconds: keep the
ESC/SHIFT
button pressed to stop the
rotation on the current display.
For each inverter it shows:
Its numeric ID (2 digits).
When the communication is in progress:
o
Counter of messages correctly exchanged with the inverter.
o
Communication errors counter.
o
Cyclically:
▪
The IP address of the inverter (only if connected via Ethernet).
▪
The inverter manufacturer
▪
The inverter model
▪
Some options read by the inverter.
When the communication is not in progress:
o
It shows the status (port opening, address acquisition etc.).
The communication counters can be reset (all together) by holding down the
ACK/ENTER
and
ESC/SHIFT
buttons for 5 seconds:
It shows information regarding the active power for the configured inverters. It uses one display
line for each inverter. If more than 7 inverters are configured, the controller shows them all,
rotating them on the display every two seconds: keep the
ESC/SHIFT
button pressed to stop
the rotation on the current display. If some measures are not available, they are displayed with
dashes.
The upper part contains the total information (sum of all inverters). This information is always
present, even if the communication with the inverters is set in BROADCAST mode. It contains:
