RN200 user manual 13
The access code set remains valid for about 10 minutes from the end of programming. After
this period, the access code must be reset to access programming again.
After authenticating with a password, it is possible to modify or reset it in the “
PROGRAM
→
1 SYSTEM
→
1.1 Security
→
1.1.2 Password
” menu
The protections and alarms are generally configurable by means of specific parameters. As a
rule, the trip time associated with the protection can also be configured.
INFORMATION! By setting the tripping time equal to 0, the protection is disabled.
Pages L.01 to L.07 contain information related to PLC logic and they are displayed only if a
valid PLC program has been downloaded to the controller. Refer to specific manuals for
information on the PLC.
This page contains the identification information of the PLC program installed in the controller,
such as:
•
The title and description of the PLC program.
•
The date of the last modification.
•
The firmware version of PLC, compiler and editor.
•
The average and maximum execution time. These times are automatically reset when
the PLC program is transmitted to the controller, or it is possible to force the reset by
pressing the
ACK/ENTER
+
ESC/SHIFT
buttons simultaneously for 5 seconds).
This page shows information related to a single PLC block.
The second row (on the right) shows the selected block, with the format "TYPE-NUMBER". To
select a block, press the
ACK/ENTER
button, then use the ▲ ▼ buttons to search for the
desired block; confirm again with
ACK/ENTER
.
The following rows show all the parameters of the selected block (one row for each parameter):
•
The first column identifies the type of parameter used (input / output).
•
The second column identifies the resource associated to the parameter. The
resources are normally shown with SICES codification (e.g. the digital input 1 is
L.02 PLC LOGIC _
PLC block: [AND-001]
| |
<out> |DI_VIRTUAL_01 | 0
<in> |DI_CONTROLLER_01 | 1
<in> |DI_CONTROLLER_02 | 0
| |
| |
| |
| |
| |