22 RN200 user manual
The total rated active power of the running inverters (W).
The total active power supplied by the inverters (W and %).
The total active power setpoint (W and %).
The following lines are related to the individual inverters. The specific information of an inverter
is available only if the communication is set in NON-BROADCAST mode. For each inverter it
shows:
Its numeric ID (2 digits).
The rated active power (W).
The active power supplied (W and %).
The active power setpoint (W).
The information of an inverter is shown in red if the inverter signals a serious anomaly, in
yellow if it signals a warning.
The active power setpoints (both the total and that of the individual inverters) are displayed
with dashes if at that moment the inverter is unable to supply the required active power (i.e. it
is producing the maximum possible, which, based on the environmental conditions, it is lower
than the required setpoint). So, the dashes indicate that no active power limitation is active on
the inverter.
It shows information regarding the reactive power for the configured inverters. It uses one
display line for each inverter. If more than 7 inverters are configured, the controller shows them
all, rotating them on the display every two seconds: keep the
ESC/SHIFT
button pressed to
stop the rotation on the current display. If some measures are not available, they are displayed
with dashes.
The upper part contains the total information (sum of all inverters). This information is always
present, even if the communication with the inverters is set in BROADCAST mode. It contains:
The total nominal reactive power of the running inverters (var). The nominal of
quadrant 1 is shown if the total reactive is positive, otherwise the nominal of quadrant
4.
The total reactive power supplied by the inverters (var and %).
The total reactive power setpoint (var and %).
The following lines are related to the individual inverters. The specific information of an inverter
is available only if the communication is set in NON-BROADCAST mode. For each inverter it
shows:
Its numeric ID (2 digits).
The nominal reactive power (var). The nominal of quadrant 1 is shown if the reactive
power supplied by him is positive, otherwise the nominal of quadrant 4.
The reactive power supplied (var and %).
The reactive power setpoint (var).
The information of an inverter is shown in red if the inverter signals a serious anomaly, in
yellow if it signals a warning.
The reactive power setpoints (both the total and that of the individual inverters) are displayed
with dashes if at that moment the inverter is unable to supply the required reactive power (i.e.
it is producing the maximum possible, which, based on the environmental conditions, it is lower
than the set point). So, the dashes indicate that no reactive power limitation is active on the
inverter.
