-39-
Model W1842 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Crown.Moulding.Support
Figure.36.
Example of crown moulding
V-Track.
Appropriate.Workpiece.Size
CORRECT
INCORRECT
Make sure to cut your workpiece to the correct width for
the knife being used (see
Figure 37). To improve knife life
and workpiece results when cutting in very hard woods,
use a table saw to rabbet out some of the profile before
running the workpiece through the planer/moulder.
Never cut into moulding that is wider than the knife.
Otherwise, the knife will overheat, burn the wood, and
dull rapidly.
When cutting crown moulding (see
Figure 36), make a
wooden V-track that can be clamped to the table. The
V-track must support at least 50% of the workpiece height
on both sides.
DO NOT use the guide rails that came with your machine
for crown moulding support. If you do, the workpiece can
dislodge and be ejected from the machine, causing severe
injury or damage.
V-Track
Figure.37.
Correct workpiece sizing.
CORRECT
INCORRECT
Summary of Contents for W1842
Page 65: ...Model W1842 For Machines Mfd Since 6 17...
Page 68: ......
