-46-
Model W1842 (For Machines Mfd. Since 6/17)
SE
RV
IC
E
SERVICE
General
MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
Tensioning/Replacing.
V-Belts
Two V-belts transfer power from the motor to the
cutterhead, and then to the infeed and outfeed rollers
with the use of the drive chain system. To ensure
efficient transfer of power to these systems, make sure
the V-belts are always properly tensioned and in good
condition.
If the V-belts are worn, cracked, or damaged, replace
them. Always replace the V-belts with a matched set of
two, or belt tension may not be even among the belts,
causing premature belt failure.
Items.Needed.
Qty
Assistant ..........................................................1
Hex Wrench 5mm ...............................................1
Open-End Wrench 12mm.......................................1
After. approximately. 16. hours. of.
operation,.V-belts.will.stretch.and.seat.
into. pulley. grooves. and. need. to. be.
properly. tensioned. to. avoid. severely.
reducing.life.of.V-belts..
V-belts. and. pulleys. will. be. hot. after.
operation.. Allow. them. to. cool. before.
handling.
Summary of Contents for W1842
Page 65: ...Model W1842 For Machines Mfd Since 6 17...
Page 68: ......
