-28-
Model W1842 (For Machines Mfd. Since 6/17)
O
PE
R
ATIO
NS
Planing.Do's.&.Don'ts
Figure.23.
Example of planing one board
at a time.
There are common mistakes that must be avoided when
planing.
Sacrificial.Table.Use
Multiple.Boards
CORRECT
Figure.24.
Example of sacrificial table
mounting.
CORRECT
INCORRECT
INCORRECT
Only plane one board at a time (see
Figure 23). Whether
you use guide rails or not, never attempt to plane more
than one board at a time side-by-side. If one board is
slightly lower that the other, the feed roller will only
hold the highest board, while the lower board will be
free to slip when the knife contacts it. This hazardous
situation can result in one board being ejected from the
machine, causing serious injury.
If using a sacrificial table, you must clamp it to the cast
iron table (see
Figure 24) to prevent workpiece ejection.
Never stack two boards on top of one another and feed
them both into the planer/moulder to compensate for a
workpiece that may be too thin. Planing with two loose
stacked boards can result in workpiece ejection, causing
injury.
Summary of Contents for W1842
Page 65: ...Model W1842 For Machines Mfd Since 6 17...
Page 68: ......