-18-
Model W1842 (For Machines Mfd. Since 6/17)
SE
TU
P
Assembly
Before beginning the assembly process, refer to
Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run
.
To.assemble.machine,.do.these.steps:
1.
Attach (1)
3
⁄
8
"-16 hex nut and (1)
3
⁄
8
" flat washer to
each of (4) feet, as shown in
Figure.11
and thread
them on all the way.
Figure.11.
Flat washer and hex nut
attached to foot.
Figure.12.
2 of 4 feet attached to cabinet.
2.
With help of an assistant, tilt planer/moulder unit
to balance on one side. To reduce risk of accidental
crushing injury place 4x4 blocks under cabinet, and
thread (2) feet all the way into mounting holes in
bottom of stand, as shown in
Figure.12
,
.
then back
feet out equally several turns.
3.
Remove 4x4 blocks, lower unit onto feet, tilt unit
onto other side, and attach remaining feet in a
similar manner. Adjust feet as needed to level
machine, then tighten hex nuts against bottom of
cabinet.
Foot
Feet
USE. helpers. or. power.
lifting. equipment. to. lift.
this.machine..Otherwise,.
serious. personal. injury.
may.occur..
x 1
x 1
4x4
Summary of Contents for W1842
Page 65: ...Model W1842 For Machines Mfd Since 6 17...
Page 68: ......