S400 S600 Operator Manual 2009
Supreme Sander
3
INSTALLATION
The Supreme Sander should be located on a flat, firm surface, in an area free of
obstructions that could interfere with the safe operation of the equipment. The
Sander should be positioned and leveled on a rubber mat to obtain quiet
operation with a minimum of vibration.
WARNING:
All electrical work must be performed by a qualified
electrician and must conform to all state and local
ordinances.
Do not, under any circumstance, tamper with, modify, or
adapt the electrical plug and cord provided with this
machine.
ELECTRICAL CONNECTIONS
Electrical connection may be made by either plugging the provided electrical cord
into an appropriately wired electrical socket, or by wiring the machine directly into
an electrical disconnect box.
WARNING:
If the electrical cord, plug or wiring should become
frayed or damaged, replace it at once. Do not attempt to
operate the machine with faulty wiring as it could result
in severe injury or death.
NOTE:
Refer to the machinery identification plate to determine
the electrical specifications of this machine in respect to
voltage, phase and amperage requirements.
WARNING:
Do not start Sander before checking for proper sanding
belt tracking.
ELECTRICAL CONTROL BOX
The electrical control box on top of the machine houses all motor controls on the
Sander. Each motor is automatically thermally protected. In case of overload,
the relay will trip and shut the motor off. The overload will automatically reset in
a short period of time.
