S400 S600 Operator Manual 2009
Supreme Sander
14
OTHER MOTORS
To remove the motor, these procedures should be followed:
1.
Disconnect the electrical power supply.
2.
From the rear of the machine, remove the four (4) screws, nuts, and
washers holding the motor. Remove V-belt.
3.
Disconnect the electrical wiring by removing the electrical plate on the end
of the motor. Mark the electrical plate on the end of the motor. Mark the
electrical wires to the motor such that you will be ABSOLUTELY CERTAIN
where to reconnect them on the new motor.
4.
Reassemble with new motor in reverse order to the above procedures.
NAUMKEAG MOTOR (optional)
To remove the Naumkeag motor, these procedures should be followed:
1.
Disconnect the electrical power supply.
2.
Remove four (4) screws, nuts and washers that hold motor to swivel plate.
Remove motor.
3.
Loosen set screw on Naumkeag shaft and remove shaft.
4.
Reassemble with new motor in reverse order to above procedures.
