Shinkawa VM-7 Series, System Manual, Page: 9 / 80

VM-7 System Manual Chapter 2 Description of the System
7
Chapter 2 Description of the System
2.1 System outline
VM-7 Series Monitor is a system which provides full-time on-line monitoring of various rotating
machineries.
Signals transmitted from the sensor installed to rotating machineries are input to the monitor
module.
The input signals can be displayed and monitored on a display PC.
If the signals reach an abnormal level, the corresponding warning will be output.
<System overview>
2.2 Installation conditions
Install the unit in a place where the following conditions are satisfied.
y Ambient
temperature:
0 to 65 ° C when the unit is operated
y Ambient
humidity
20 to 90%RH (no condensation) when the unit is operated
y Vibration
condition
2 m/s
2
or less at 10 to 100 Hz
y Air cleanliness
level
Ideally, with the air dust level at 0.2 mg/m
3
or less.
Also, keep away from corrosive gases including hydrogen sulfide gas,
chlorine gas, as well as electrically conductive dust such as iron and carbon.
MCL View
software
FIELD
CONFIG
software
Power system1 or 2
AC or DC
Display PC
Phase marker input × 2ch
Control contact input
y Alarm reset
y Sequence
y Filter enable
Service PC
Transducer input
Power output for transducer
Monitor output
Front BNC & Rear
connector
Recorder output
Contact output
Output for upper network
Modbus/TCP
(Compatible with redundancy)