9
Mode -02- (Elapsed Time Measurement/Monitoring)
The following parameters must be set in mode -02- so that the DT-5TXR/DT-5TS will display the correct readings:
Except for parameter 3, the instructions are the same for setting the parameters as in mode -01-.
Instructions for setting the parameters in mode -02- are as follows:
1. Press the PAR button.
2. Use the NUMERIC buttons to enter the number of pulses per revolution.
3. Press the PAR button.
4. Press the NUMERIC buttons to enter the sensing RPM.
5. Press the PAR button; the display will reflect:
The secondary display A reflects that the meter is in mode -02-, but parameter 3 is showing on the primary
display (10 sec [factory setting]).
6. Use the NUMERIC buttons to enter the number of seconds to the hundredth place (000.00). If time in hours,
minutes, and seconds is necessary, press the NEGATIVE/DECIMAL POINT button, then use the NUMERIC buttons
to enter the amount of time as it relates to the already programmed RPM setting.
7. Press the PAR button.
8. Use any of the lower buttons to scroll through (see table above) and select an update time.
9. Press the PAR button.
10. Use the NUMERIC buttons to enter the time in seconds that the display should hold in the final reading.
11. Press the PAR button.
12. Refer to the “Sensor Connection” table under the “Set-Up” section for the proper filter for the sensor being
used. Press any of the lower buttons to scroll through the input filters (see table above) until the desired reading
is showing.
13. Press the SET button to store the parameters and exit.
NOTE: Please see page 13 for an example of MODE -02-.
DISPLAY
MEANING
1
Pulses p
9
9
9
9
–
1
n
o
it
u
l
o
v
e
r
r
e
_ _
0001
1 p/r
2
Sensing
U
M
P
R
p to 99999
_
01000
1000 RPM
a)Hours, Minutes, Seconds
0 : 00 : 00 – 9 :59 : 59
b)Seconds
0 : 00 – 999 : 99
4
Update time
0.2, 0.5, 1.0, 2.0, 5.0, 10 , 15, 30, 60 seconds
_
1.0
_
1 second
5
Display “Hold” after input signal ceases
0.1 – 150 seconds
_ _
006.0
6.0 seconds
6
Inp
0
1
r
e
tl
if
t
u
, 30, 100, 0.02 KHz
10
10 kHz
10.0 seconds
Display units
3
_
010 : 00
FACTORY SETTING
RANGE
DESCRIPTION
PARAMETER
www.
GlobalTestSupply
.com
Find Quality Products Online at:
