16
All outputs should be isolated through an opto-coupler.
Each transistor can handle up to 30VDC and no more
than 20mA.
DT-5TXR with DOP-TRTR Module
DT-5TXR-TRTR
The DT-5TXR panel meter with the DOP-TRTR
module provides two high set points (limits)
and two low set points in addition to the normal GO
signal output. The module have an additional
ZERO speed signal output feature which is very useful in
many applications.
Connect proper voltage (AC or DC depending on model)
between pin 1 and 2 and set your mode, parameters
etc. as described in previous pages and follow the
instructions described on page 11 to set up the two sets
of low and high set points (limits).
When using the DOP-TRTR module, the various outputs
will appear on the terminal strip as shown below:
DT-5TXR with DOP-FVTR or DOP-FVC Module
DT-5TXR-FVTR/DT-5TXR-FVC
The DOP-FVTR or DOP-FVC module coupled with the DT-
5TXR panel meter provides three popular voltage outputs
and one current output for recording purposes and PLC
applications. The voltages are:
a) 0 to 10 VDC
b) 1 to 5 VDC
c) 0 to 1 VDC
d) The current is 4 - 20mA
NOTE: Only one output can be used at a time.
The different outputs are not achieved through
programming, but by making the proper connections.
The connections for the DOP-FVTR module are as follows:
MODEL
Current Output
4 – 20 mADC
0 – 10 VDC
1 – 5 VDC
0 – 1 VDC
Current Output
Less than 500
Ω
Voltage Output
1 k
Ω
or higher
DOP-FVT/DOP-FVC
Voltage Output
Load
Output
DESIGNATION
DESIGNATION
1
19
2
20
3
21
4
22
5
23
6
24
7
25
8
26
9
27
10
28
11
29
12
30
13
31
14
32
15
33
16
34
17
35
18
36
PIN No.
NC
GND
NC
GND
0-10 VDC
NC
4-20 mA Plus
4-20 mA Minus
NC
GND
0-1 VDC
NC
1-5 VDC
NC
The voltage output will be linear and directly correspond
with programmed maximum and minimum RPM values.
Connections for the DOP-FVC module are as follows:
www.
GlobalTestSupply
.com
Find Quality Products Online at:
