22
Web-site: www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
Radio
- Listening to the Radio -
Listening to the Radio
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button until “FM” or “AM” appears on
the display.
3
Press the TUNING (
X
X
X
X
X
or
W
W
W
W
W
) button on the remote control to tune
in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast
station.
Notes:
●
This can be operated by using the remote control only.
●
When radio interference occurs, auto scan tuning may stop automatically
at that point.
●
Auto scan tuning will skip weak signal stations.
●
To stop the auto tuning, press the TUNING button on the remote control
again.
●
When an RDS (Radio Data System) station is tuned in, the frequency will
be displayed first, and then the RDS indicator will light. Finally, the station
name will appear.
●
Full auto tuning can be achieved for RDS stations (see “ASPM” on page 26).
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display “ST”.
●
“
j
” will appear when an FM broadcast is in stereo.
●
If the FM reception is weak, press the TUNER (BAND) button to extinguish “ST”.
The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
FM stereo mode indicator
FM stereo receiving indicator
*MD9000H-E22-23
2001.4.20, 2:57 AM
22
