SHAREBOT Next Generation, User Manual, Page: 62 / 66

62
The use of the machine to perform operations other than those described above may only be carried out after consulting the SHAREBOT S.R.L. and with the
written consent of the same.
The machine has been designed and built to work in environments where there is a potentially explosive atmosphere and by itself cannot generate a potentially
explosive atmosphere.
The use of the machine for different transactions may cause damage to persons or to the machine itself and are therefore considered improper for which the
manufacturer will not be liable.
ATTENTION: in case of a different intended use is essential to consult in advance with the manufacturer’s technical department.
2.7. Warnings and general rules of conduct
In order to avoid any risk to people or damage to the machine, it is recommended to carefully follow the instructions and General behavior rules herein.
WARNING: the manufacturer declines all responsibility for damages to things and/or people resulting from improper interventions carried out by unqualified,
untrained or unauthorized use.
WARNING: prevent the machine from being used by unauthorized personnel or by personnel not trained without supervision: in fact, before starting work,
each user must be perfectly aware of the position and operation of all commands and the characteristics of the machine; must also have read this manual in
its entirety.
- Before using the machine make sure that any security-threatening condition was properly deleted and that there are no dangerous areas and operators in the
vicinity of the machine.
- Before using the machine, ensure that all guards or other protections are in place and that all safety devices are present and efficient.
- Consult this manual as regards the applicable safety requirements and specific to dpi for personal safety; in particular, however, the machine personnel should
wear appropriate clothing, avoiding or paying due attention to:
- fluttering clothes,
- wide sleeves,
- ties or scarves dangling,
- necklaces, bracelets and rings.
- The work area must never be taken to interfere with the freedom of movement of the user.
WARNING: tampering with or unauthorised replacement of one or more parts of the machine and the use of accessories, utensils, supplies other than those
specified by the manufacturer can result in risk of injury.
3 | Transport and Installation
3.1.1 Environmental Conditions of the installation Site
The machine does not require special environmental conditions for its operation.
The machine must be installed and work in closed rooms protected against atmospheric agents.
CAUTION: make sure in any case that ambient lighting is sufficient to operate safely; If not, you must install one or more light sources appropriately spread
DANGER: the machine installation must be equipped, by the customer, appropriate forced ventilation system (recommended 30 air changes per hour), to avoid
inhalation of the fumes produced by the extrusion process.
MINIMUM SPACE FOR INSTALLATION OF THE MACHINE
The installation at the place of work must be done so that the machine and its equipment are accessible to allow the correct use. For the choice of the place, as
a general rule, it is necessary to take care that the user can move freely around the machine.
3.2. Transport and handling
The transportation and handling of the machine may occur in the following situations:
storage of the machine;
- Assembly and installation of the machine;
- Uninstallation and disassembly of the machine;
- Moving and relocation of the machine.
Please refer also to the instructions regarding the residual risks and specific warnings.
To perform the task under consideration requires the following personal protective equipment: