SHAREBOT Next Generation, User Manual, Page: 17 / 66

17
reel-carrier without any hindrances or preventing the entrainment of the wire by the extruder. For
this reason, the printer may not be placed on a shelf that is at least 35 cm free space around the rear
or side.
Assembling the reel-carrier
The two sides of the triangle shaped and coils are identical; start with the screw on a nut on one side
of the threaded bar, leaving 15mm of thread and repeat on the other side. Now insert the threaded
bar on the shoulder using the hole on the top of the triangle and fix it with the nut. Do not overtighten
to avoid breaking the plexiglass. Insert the reel and attach the second shoulder. Place the door coils
behind or sideways into the printer recalling that the wire must carry out unhindered and in the di-
rection of the extruder.
Unlocking the extruder
To avoid damage during transport, the blocking of the extruder is secured with clamps. The clamps
must be carefully cut and removed to allow the extruder to move freely. DO NOT feed the printer until
you have done this step otherwise you will damage the motors and mechanics.
Remove all packaging inside the machine.
Parking second extruder
If you have purchased a NG with double extruders this operation is crucial to the success of your
prints; loosen the allen screw on the plate that connects the two carriers, we can move in parking
position (to the left) the second extruder, which will be coated in the left shoulder by a magnet. This
operation is essential to perform calibration.