SHAREBOT Next Generation, User Manual, Page: 27 / 66

27
material and higher values increase the extruded material from the value predicted by the G-Code.
In all cases, it is a percentage.
The latest rumor concerning the change of the filament while printing: the procedure arises from the
need to replace the filament out with a new reel for use until after the previous coil, but this item can
also be used to change the color of the filament or even the same type of filament by maintaining the
ability to continue printing without defects in the object.
The procedure starts with the shift of the extruder in parking area, then the engine expels the cur-
rent thread and the internal buzzer is activated as soon as the extruder is unloading. When you have
positioned the new wire on the inlet hole and you did it so I hit the drive sprocket you must press the
knob to start dragging and extrusion which reloads the casting chamber and also allows you to expel
the remnants of previous material. When the flow of new wire is satisfactory, press the menu knob
again to resume printing.