SHAREBOT Next Generation, User Manual, Page: 61 / 66

61
vices of the same.
- Before operating the machine, verify that you have restored all of its safety devices.
2.4 Recommendations on the safety
On the machine are present the signal plates shown in the table 2.
Table 2 – Description of the plates these reporting
PLAQUE DESCRIPTION
A Plaque CE.
B Indicates the danger of electrocution at electrical casings of the machine where it is positioned.
C The obligation to wear specific PPE (eyewear) during use of the machine.
D Signals the danger due to the presence of moving bodies at the point where the machine is placed.
E Points out the danger of crushing at the point where the machine is placed.
F Report the presence of hazard hot surfaces at the point where the machine is placed.
G The danger for the presence of artificial optical radiation (LED) at the point where the machine is placed.
2.5 Indications about noise and vibrations
The machine was designed and constructed in such a way as to minimise the noise level during normal operation, taking account of technical progress and of
the ability to have means to limit noise.
In any case, the acoustic pressure emitted by the machine and measured at the workstation provided is less than 70 dB (A).
Under conditions of use in accordance with manufacturer’s instructions in this manual, the vibrations are not such as to give rise to dangerous situations.
The operator however, if vibrations occur, must stop the machine immediately and report the problem in writing to the manufacturer’s assistance service sup-
port@sharebot.it
2.6 Proper and improper use of the printer
The machine is designed and created for the purpose of creating prototypes and objects in three dimensions, starting from a technical drawing.
The materials that the machine can work are PLA plastic strands, ABS, ABS plus, Nylon, rubber, Polystyrene, Cristal TPU Flex, PLA sand, PLA wood with a diam-
eter of 1.75 mm.
The machine needs electric power.