GB
SGM Technology for lighting
Genio Mobile
User Manual 1.00
- 45 -
Step 14 – ENABLING SCENES
Enabling a scene decides if the scene will be run or not when the program is run. The SCNRUN menu is also
useful when it is necessary to temporarily eliminate the playback of some scenes in a program without
cancelling them.
1.
Use the UP key to pass to the “SCNRUN=OFF” menu
2.
Press “Enter” and “SCNRUN=” will begin to flash
3.
Use the UP/DOWN keys to choose ON to enable the scene, or OFF if it has not
to be run.
4.
Press “Enter” to exit the SCNRN menu and confirm
Repeat the above steps to program other scenes on the Genio Mobile.
Once programming is finished, keep “Enter” pressed down for approximately 6 sec. In order to exit the
PROGRAMMER menu
.
Step 15 - PROGRAM PLAYBACK
To start the playback of a program, access the PRGRUN menu
1.
Use the UP/DOWN keys to find the “PRGRUN” menu
2.
Press “Enter” and the displayed text will immediately begin to flash
3.
Use the UP/DOWN keys to choose the required programs from 1 to 2, or OFF
to stop the playback of the current program.
4.
Press “Enter” to exit the PRGRN menu and confirm
THE EVENT SCHEDULER
Scheduler is a Genio Mobile menu that allows to organize a series of 48 events over a period of a week and
which are repeated week after week. Each event can control the day and time of the start and finish of one
of the ten programs already prepared on board the Genio Mobile, in order to automate playback, without
the need for any external operators.
ATTENTION:
Before proceeding with the programming of the Scheduler, it’s important to set the
current date and time (See Chap.
Menu
- paragraph:
Days of the week and time
)
Step 1 – CHOOSING THE EVENT NUMBER
1.
Use the UP/DOWN keys to find the “SCHEDULER” menu
2.
Press “Enter” for a few seconds, until the following appears: “EVENT=1”
3.
If it is necessary to create a event other than number 1, press “Enter” again
and “EVENT=” will begin to flash
4.
Use the UP/DOWN keys to choose the required event, from 1 to 48, then
Press “Enter” to exit the EVENT menu and confirm.
Step 2 - CHOOSING the PROGRAM number
1.
Use the UP key to pass to the “PROGRAM=1” menu
2.
Press “Enter” and “PROGRAM=” will begin to flash
3.
Use the UP/DOWN keys to choose the required program number (from 1 to 2)
to be controlled by Scheduler.
4.
Press “Enter” to exit the PROGRAM menu and confirm
SCNRUN=ON
PRGRUN=1
EVENT=1
SCHEDULER
PROGRAM=1
