GB
SGM Technology for lighting
Genio Mobile
User Manual 1.00
- 33 -
3.23
Test function
Using the test menu, it’s possible to test the correct operation of the channels that control the Genio
Mobile.
1.
Use the UP/DOWN keys to find the “TEST” menu
2.
Press “Enter” and hold it down for a few seconds to confirm the choice. The
text on the display will begin to flash.
3.
Use the UP/DOWN keys to select the physical channel to be tested
(ALL - PAN - TILT - SHUTT - DIMMR - RED - GREEN - BLUE - CTC)
4.
Press “Enter” and the selected text will begin to flash, running a test routine
on the chosen channel.
5.
Press “Enter” again to exit the routine being run and choose another channels
to be tested
6.
Keep “Enter” pressed down for a few seconds if you wish to exit the TEST
menu
3.24
Head and motors card temperature
The TEMPERATUR menu is used to view the current temperature of the Genio Mobile’s head and motors
card.
1.
Use the UP/DOWN keys to find the “TEMPERATUR” menu
2.
Press “Enter” and the “HEAD=xx°C” menu, that shows the current
temperature of the head in degrees Centigrade, will be immediately
displayed.
3.
Using the UP/DOWN keys, it’s possible to display the temperature in degrees
Centigrade or Fahrenheit of the head and the motors card.
4.
Press “Enter” to exit the TEMPERATUR menu
3.25
Configuring as Master
When a system with several interconnected fixtures has to be used in Stand-alone mode, there has to be
one MASTER fixture, able to control the other fixtures, via appropriate on-board programming.
1.
Use the UP/DOWN keys to find the “MASTER” menu
2.
Press “Enter” and the displayed text will immediately begin to flash
3.
Use the UP/DOWN keys to choose ON or OFF status
4.
Press “Enter” to exit the MASTER menu
3.26
Configuring Slaves
When a system with several interconnected fixtures has to be used in Stand-alone mode, there has to be
one MASTER fixture, whereas each of the fixtures controlled by it must be individually configured with its
own SLAVE number. In the event of the same ID being used for several fixtures, they will not be able to be
controlled individually by the MASTER program.
1.
Use the UP/DOWN keys to find the “SLAVEID” menu
2.
Press “Enter” and the displayed text will immediately begin to flash
3.
Use the UP/DOWN keys to choose the required ID (from 1 to 29)
4.
Press “Enter” to exit the SLAVEID menu and confirm
TEST=BLUE
TEMPERATUR
HEAD=21°C
MASTER=ON
SLAVEID=12
