SGM Technology for lighting
GB
User Manual 1.00
Genio Mobile
- 32 -
3.20
Time
It’s just as important to set Genio Mobile’s on-board clock if it has to be used later in Stand-alone mode.
1.
Use the UP/DOWN keys to find the “C” (Clock) menu
2.
Press “Enter” to confirm the choice. The first two numbers (relative to the
hours) will begin to flash on the display.
3.
Use the UP/DOWN keys to select the current time (the hour – from 00 to 23).
4.
Press “Enter” to move the setting from the hours to the minutes
5.
Use the UP/DOWN keys to select the current time (the minutes – from 00 to
59).
6.
Press “Enter” to move the setting from the minutes to the seconds
7.
Use the UP/DOWN keys to select the current time (the seconds – from 00 to
59).
8.
hold “Enter” pressed down for approx. 6sec. to confirm the new time
3.21
Setting default parameters
This enables to set the default parameters:
1.
Use the UP/DOWN keys to find the “FACT” menu.
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select the ”FACT=SET” and press “Enter”
4.
Press “Enter” to set the default parameters shown in the table.
“FACT=OFF” appears on the display.
Menu item
Default parameter
ADDR
001
PMOVE
NORM
PP_MIN
0
PP_MAX
540
TMOVE
NORM
TP_MIN
0
TP_MAX
270
SWAP
OFF
BRIGHT
40%
DMXDLY
UNL
3.22
Resetting default parameters
This enables to reset the parameter values set immediately before the FACT=SET operation. In other
words, if the default parameters have been set by mistake, this operation allows to revert to the values set
previously.
1.
Use the UP/DOWN keys to find the “Prev” menu
2.
Press “Enter” and hold it down for a few seconds to confirm the choice.
The text on the display will begin to flash.
3.
Use the UP/DOWN keys to select ”PREV=SET”
4.
Pressing “Enter” in this mode resets the values, cancelling the FACTORY
DEFAULT operation. In the meanwhile, PREV stops flashing and the
message that appears is PREV=OFF
FACT=SET
FACT=OFF
C 12:06:20
PREV=SET
PREV=OFF
