33
Product Version 1.0 | Revision E | Released 2023-01-11
All gobos are indexed and marked in the gobo wheel to ensure they show correctly when installed. When replacing
a gobo, it is important to align the gobo with the gobo holder and the gobo wheel to ensure the image on the gobo
is upright when the wheel is indexed upon start-up calibration.
To replace a gobo:
GOBO REPLACEMENT
Figure 20: Tilt lock
Figure 21: Removing the head cover
Figure 22: Removing the gobo wheel hatch
TORX 20
Gobo Wheel Hatch
Polytetrafluoroethylene
Membrane
TORX 20
Gobo Wheel Hatch
Polytetrafluoroethylene
Membrane
1. Disconnect fixture from power and allow it to cool.
2. Position the head as needed and engage the tilt lock
3. Remove the rear head cover in which heat sink fins are
visible through the vents (fans are visible through the
other cover). Then, loosen the screws to remove the rear
of the head cover (fig 21).
4. Remove the gobo wheel hatch by removing the six
screws (fig 22.).
