40
Product Version 1.0 | Revision E | Released 2023-01-11
MAINTENANCE NOTES
1. In rough service environments such as with dust or fog/haze media in the air, inspect fans every 6 months at
minimum.
2. Threadlocker must be used if replacing or re-installing hardware. Consult SGM authorized serice center for
instructions and further information.
3. If any part is cracked, no matter the size, contact SGM Support.
4. Internal parts can sometimes be subjected to overheating due to magnification of sunlight. Look for discolor-
ed or deformed components.
*G Series luminaires do not require lubrication under normal circumstances. Approved lubricants can be reapplied
by an SGM authorized serice center.
CLEANING
SGM fixtures with IP66 rating do not need any cleaning procedures inside the fixture. However, cleaning the front
lens may be needed to achieve the maximum light output after exposure to dust, sand, or dirt. Exterior housing can
also be cleaned to obtain a better look. To maintain adequate cooling, fans must be cleaned periodically.
Whenever necessary, clean the G-7 BeaSt using a soft cloth dampened in water. For the front lens the front lens use
regular glass cleaner. For thorough cleaning of plastic and metal exterior, use plastic cleaner such as SONAX PRO-
FILINE Interior Plastic Cleaner. Do not use products that contain solvents, abrasives, or caustic agents for cleaning,
as they can cause damage to hardware, cables, and connectors. Consult www.sgmlight.com or contact SGM Light
support if you have any questions about cleaning and maintenance.
Cleaning will vary greatly depending on the operating environment and installation. It should therefore be checked
at frequent intervals within the first few weeks of operation to see how often cleaning is necessary.
