35
Product Version 1.0 | Revision E | Released 2023-01-11
Carefully re-insert the aligned gobo and gobo holder. There are two springs which secure each gobo holder in the
gobo wheel. It may be helpful to use needle-nose pliers to assist the re-insertion of the gobo holder.
All gobos are indexed and marked in the gobo wheel to ensure they show correctly when installed. When replacing
a gobo, it is important to align the gobo holder with the gobo wheel to ensure the image on the gobo is upright
when the wheel is indexed upon start-up calibration.
GOBO HOLDER
INDEX MARK
GOBO HOLDER
RETAINING SPRING
GOBO HOLDER
GOBO WHEEL
Figure 25: Gobo holder top view
POLYTETRAFLUOROETHYLENE (PTFE) MEMBRANE
Gobo Hatch
Polytetrafluoroethylene
Membrane
After the gobo wheel hatch has been re-installed,
the fixture must be vacuum tested.
The gobo hatch includes a Polytetrafluoroethylene
Membrane, which allows the fixture to breathe.
In order to vacuum test the fixture, the PTFE Mem-
brane must be removed.
Vaccum testing requires a specialized kit. This can
be purchased seperately. For more information on
how to vacuum test the G-7 Spot, please contact
[email protected]
Figure 26: Polytetrafluoroethylene Membrane
