6
Startup
Requirements
Operating Instructions – MOVIFIT
®
FC
128
INFORMATION
To ensure fault-free operation, do not disconnect or connect the signal cables during
operation.
6.2
Requirements
The following conditions apply to startup:
• MOVIFIT
®
and the drive units must be installed correctly both mechanically and
electrically.
• Appropriate safety measures prevent the drives from starting up unintentionally.
• Appropriate safety measures must be taken to prevent risk of injury or damage to
the machine.
The following hardware is required for startup:
• PC or laptop
• Interface adapter
• Connection cable between PC and MOVIFIT
®
The following software is required on the PC or laptop for startup:
• MOVITOOLS
®
MotionStudio, version 5.60 or later
6.3
Description of the DIP switches
6.3.1
Notes
NOTICE
Hazard caused by unsuitable tools.
Damage to the DIP switches.
• To set the DIP switches use only suitable tools, such as a slotted screwdriver
with a blade width smaller than 3 mm.
• The force used for setting the DIP switches must not exceed 5 N.
INFORMATION
For information about the position of DIP switches S10 and S11, refer to the "EBOX"
chapter.
For information about the position of DIP switches S1, S2 and S3, refer to the
"ABOX" chapter.
6.3.2
DIP switch S1
Bus terminating resistor for PROFIBUS
• DIP switch S1 = OFF: Bus terminating resistor is
not
active.
• DIP switch S1 = ON: Bus terminating resistor is active.
21316996/EN – 12/2014