SEW-Eurodrive Movidrive MDX60B, Compact Operating Instructions

Page: 27 / 64

6
Service
Fault messages and list of faults
Compact Operating Instructions – MOVIDRIVE
®
MDX60B/61B
27
Fault Subfault
Code Designation Response
(P)
Code Designation Possible cause Measure
14 Encoder Immediate
stop 0 Encoder not connected,
defective encoder, defect-
ive encoder cable • Encoder cable or shield not
connected correctly.
• Short circuit / broken wire in
encoder cable
• Encoder is defective.
• When 2 inverters are con-
nected via X14 and P505 is
set to YES F14 SubC 27.
• Check encoder cable and
shield for correct connec-
tion, short circuit and
broken wire
25 Encoder fault X15 –
Speed range exceeded
Encoder exceeds
6542 min
-1
26 Encoder fault X15 – Card
is defective
Fault in the quadrant eval-
uation.
27 Encoder fault – encoder
connection or encoder is
defective
28 Encoder fault X15 – Com-
munication fault RS485
channel
29 Encoder fault X14 – Com-
munication fault RS485
channel • Encoder cable or shield not
connected correctly.
• Short circuit / broken wire in
encoder cable
• Encoder is defective.
• When 2 inverters are con-
nected via X14 and P505 is
set to YES F14 SubC 27.
• Check encoder cable and
shield for correct connec-
tion, short circuit and
broken wire
30 Unknown encoder type at
X14/X15
31 Plausibility monitoring fault
Hiperface
®
X14/X15
Increments have been lost
32 Encoder fault X15
Hiperface
®
Hiperface
®
encoder at X15
signals a fault
33 Encoder fault X14
Hiperface
®
Hiperface
®
encoder at X14
signals a fault
34 Encoder fault X15 resolver
– Encoder connection or
encoder is faulty
17 System fault Immediate
stop 0 "Stack overflow" fault Inverter electronics disrupted,
possibly due to EMC influences • Check grounding and
shielding and improve, if
necessary
• Consult SEW Service if the
fault occurs again.
18 "Stack underflow" fault
19 "External NMI" fault
20 "Undefined opcode" fault
21 "Protection fault"
22 "Illegal word operand ac-
cess" fault
23 "Illegal instruction access"
fault
24 "Illegal external bus ac-
cess" fault
25 EEPROM for rapid stop 0 Read or write fault on
EEPROM power section Access to the EEPROM of the
memory card has failed • Restore factory settings,
perform reset and reset pa-
rameters.
• Consult SEW service if the
fault reoccurs
• Replace memory card
11 NV memory read fault
NV-RAM inside the unit
13 NV memory chip card
memory module defective
14 NV memory chip card
memory card defective
16 NV memory initialization
fault
26 External ter-
minal Emergency
stop (P) 0 External terminal Read external fault signal via
programmable input Eliminate respective cause;
reprogram terminal if neces-
sary
24770531/EN – 11/2017