SEW-Eurodrive ECDriveS, Manual, Page: 9 / 56

2
Safety notes
Electrical installation
Manual – ECDriveS
®
9
2.8 Electrical installation
Ensure that all of the required covers are correctly attached after carrying out the elec-
trical installation.
Make sure that preventive measures and protection devices comply with the applic-
able regulations (e.g. EN 60204-1 or EN 61800-5-1).
2.8.1 Required preventive measure
Make sure that the product is correctly attached to the ground connection.
2.8.2 Stationary application
Necessary preventive measure for the product is:
Type of energy transfer Preventive measure
Direct power supply
• Ground connection
2.9 Startup/operation
Observe the safety notes in the chapters "Startup" (→
2
19) and Operation in the
documentation.
Ensure that all required covers are mounted properly before applying the supply
voltage.
Depending on the degree of protection, products may have live, uninsulated, and
sometimes moving or rotating parts, as well as hot surfaces during operation.
In the event of deviations from normal operation, switch the product off. Possible devi-
ations are increased temperatures, noise, or vibration, for example. Determine the
cause. Contact SEW‑EURODRIVE if necessary.
Mechanical blocking or internal protective functions of the product can cause a motor
standstill. Eliminating the cause of the problem or performing a reset may result in the
drive restarting automatically. If, for safety reasons, this is not permitted for the drive-
controlled machine, first disconnect the product from the supply system and then start
troubleshooting.
Risk of burns: The surface temperature of the product can exceed 60 °C during opera-
tion. Do not touch the product during operation. Let the product cool down before
touching it.
25938274/EN – 01/2019