SEW-Eurodrive ECDriveS, Manual, Page: 24 / 56

5
Startup
Startup of "full PLC configuration"
Manual – ECDriveS
®
24
SNMP (Simple Network Management Protocol) as a protocol for network diagnostics
extends the topology detection by standard diagnostics mechanisms from the IT area.
INFORMATION
If you use the ECC-DFC fieldbus controller in ZPA mode, the topology detection is re-
quired without fail.
Creating a system topology
You can configure the system topology in various different ways. The offline configura-
tion is described below.
1. To create the system topology, open the "Topology view" tab.
25272967307
2. Connect the ports by dragging and dropping and then transfer the configuration to
the PLC.
25301385739
3. To check that the configured system topology matches the online topology, switch
to the online view.
ð
Green: The system topology matches.
ð
Red: The system topology does not match.
25938274/EN – 01/2019