Servomex Servotough SpectraScan 2400, User Manual

Page: 65 / 76

SERVOTOUGH SpectraScan User Manual
02400001A/1 63
Figure 18 - Accessing the Light Source
5. Remove the connector with the green wires from the bottom edge of the light source circuit
board as shown in Figure 19. The black connector has a squeeze tab to prevent accidental
release of the connector.
6. Using a 3/32” hex wrench, loosen and remove the four bolts and four lock washers at the
corners of the light source circuit board. Lift the blue light source circuit board up and out of
its mounting hole. This circuit board with the light source on the other side of it is the light
source assembly (see Figure 20).
7. The light source assembly shall be replaced as a whole. It shall not be reduced to smaller
components or repaired. The old assembly can be discarded in accordance with
appropriate local regulations.
Figure 19 - The Light Source Circuit Board