TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The motor reducer
does not work
No voltage
to the motors
Check the presence of voltage at the power supply input
clamps to the motor.
Check that the power supply cable is not interrupted.
(The power supply cable must be replaced by an
authorised technician)
Check the fuses on the control unit.
No voltage
to the control unit
Check the network fuse and the presence of network voltage.
Intervention of the motor
circuit breaker
Leave the motor at a standstill for 10 minutes
and re-attempt functioning.
The gate does
not complete
its run
Gate lock
Release the motor manually and move it manually
to check that there are no obstacles.
Remove any obstacles.
The gate
has difficulty
starting
Condensers depleted
Measure the capacity of the condenser
and replace it if necessary.
Incorrect motor thrus
regulation
Repeat programming by increasing the motor thrust using
the "Power" potentiometer.
Peak on start-up
deactivated
Control the relative micro switch on the board.
Incorrect work times
Repeat work times programming.
Incorrect slowing
setting
The radius
of action of the
remote controls
is reduced
Antenna connection
unsuitable
Check that the antenna is connected correctly to the
clamps 23-24.
An external antenna
is required
To have the maximum reception distance, replace the
internal antenna of the flashing light with an external
SERAI OG/50 -SR 25.50-
Use of a SOG/4A
receiver
Replace the receiver incorporated with the SOG/4A
board.
K
IT
/A
9
I
E
0
2
1
8
1
2
0
2
1
4
-
A
4
V
f/
r
-
IS
K
IT
/A
9
-E
WARRANTY CONDITIONS
The company reserves the right to make any modifications without forewarning. The conventional guarantee of SERAI product is valid for 24 months from the date of issue of the fiscal document,
which proves purchase and is applied in the seat of Legnaro - PD - or at authorised After-sales Centres. The transport costs are under the Customer's responsibility.
WEEE DIRECTIVE 2002/96/CE REGARDING THE DISPOSAL OF WASTE ELECTRIC AND ELECTRONIC ELEMENTS
This appliance has been produced after 13/08/2005. To protect the environment: at the end of use, do not dispose of the appliance as common mixed waste, but deposit it
at a WEEE collection centre (Waste Electric and Electronic Equipment).
CE DECLARATION OF CONFORMITY
SERAI spa declares that the KIT/A9 product has been designed and realised with respect to the Directives and Standards stated above.
Check that the slowing speed set is sufficient to move the gate,
if necessary try and exclude slowing -dip2 SW2 in ON-
By excluding the slowing the gate bangs against the
mechanical stops causing a, more or less, loud noise,
according to installation. Also, the internal gears are
subject to greater stresses.
E L E T T R O N I C A P A D O V A
I
S
IN
C
E
1
9
6
5
M A D E I N I T A L Y
VIA ENRICO FERMI, 22
35020 LEGNARO - PADOVA
I T A L I A
PHONE +39 049 79 08 58
FAX +39 049 88 30 529
E-MAIL [email protected]
WEB www.serai.com
