+49 33631 59 650
[email protected]
w w w .sensys.de
Manual
SBL10
42 / 69
Version 1.27
It is possible to switch between field map and field list at any time. To do so, tap "Menu" and select
"Field list" (5) or "Field map". To set the project, select "Project settings" (6). All relevant project
settings are made here.
A) Reference Coordinate
The reference coordinate can be entered manually or it is identified from the connected GPS. It is
the coordinate origin of the field maps local coordinate system and the basis for coordinate
transformation when referencing a field.
B) Sensor Configuration
The sensors position is especially important when doing line measurements, as it indicated the
probes position in relation to the GNSS antenna. The draft (7) given below explains in detail which
values need to be entered.
C) GPS Configuration
In case a GNSS is being used, then the configuration which is required for the current project needs
to be entered here. If the set "min. GPS quality" is not available, the GPS stat (3) will switch to
"insufficient". If this is the case, then the system will not allow a position measurement.
D) Common
The operator can be set here. This information is saved in the raw data and will be transferred along
with the measurement data for data evaluation.