SENSORPROX 100R/PIN120 -
SINGLE DOOR CONTROLLER
22
12-70. Set Door Contact Sensor Input Detection from ‘H’ to ‘L’
Door Contact input is detected on the falling edge of Door Contact input
(Defaulted setting)
Configuration Card
/Configuration PIN
12-71. Activate TTL Output to ‘H’
TTL output changes the state from logic '0' to logic '1' when it activates.
Configuration Card
/Configuration PIN
12-72. Activate TTL Output to ‘L’
TTL output changes the state from logic '1' to logic '0' when it activates.
(Defaulted setting)
Configuration Card
/Configuration PIN
12-77. Enable Chime Bell Output
Configuration Card
/Configuration PIN
(Defaulted setting=Enable)
12-78. Disable Chime Bell Output
Configuration Card
/Configuration PIN
12-80. Set Delay Time to Activate SECURE MODE
(
mm
=00~99 min., Defaulted Delay time= 00 min.)
Configuration Card Command
Delay time
/Configuration PIN]
12-81. Set Door Open Time-out for Door Contact Sensor
(
tt
=00~99 sec., Defaulted value = 00 sec. means no detect Door Contact Sensor, refer
to 12.24 for Alarm time settings)
Configuration Card
Command
Door Open time-out
/Configuration PIN
