eMotion
in-depth guide
Note:
If the flight line spacing is low enough to cause your drone to
overshoot the beginning of a flight line,
eMotion
will automatically
switch to an alternating flight line pattern. Your drone will fly along
every other flight line, then return to fill in the gaps. If the spacing
becomes too small even for an alternate flight lines, a
will appear
beside this parameter to indicate the warning. You can remove this
warning by decreasing the Lateral overlap or the Ground resolution.
•
Mean flight lines altitude above elevation data:
Mean altitude differ-
ence between all flight lines and the ground altitude, based on the top-
most elevation data layer (3D flight planning only).
•
Max flight lines altitude above elevation data:
Maximum altitude dif-
ference between a flight line and the ground altitude, based on the top-
most elevation data layer (3D flight planning only).
•
Min flight lines altitude above elevation data:
Minimum altitude differ-
ence between a flight line and the ground altitude, based on the top-most
elevation data layer (3D flight planning only).
•
Distance between photos:
The required distance between each consec-
utive photo taken in the same flight line, calculated using the Longitudinal
overlap, Ground resolution and Camera model parameters. The wind also
has an influence as the ground speed increases with back wind.
Note:
The
eBee RTK
has a minimum distance between photos that
depends on the wind speed and direction. If the calculated distance
that is too short will be indicated with a
icon. This is not critical for
the flight, but it may reduce the longitudinal overlap of the images.
Consider reducing the ground resolution (fly higher) to achieve the
selected longitudinal overlap, or reduce the longitude overlap itself
to remove this notice.
•
Single image coverage:
The estimated ground area covered by a single
127
Summary of Contents for EBEE RTK
