SCP 2100
– User Manual
Page 18 (62)
1. Screen title.
2. Icons indicate which control buttons are currently valid for entry.
3. Cursor shows which line is active.
4. When editing, active character or item is highlighted.
3.2 Network Setup via Front Panel
The SCP 2100 can be setup on a network connection to allow remote management and
SNMP configuration. For these features to work, the network settings for the SCP 2100
must first be configured properly for the network it is connected to.
Configuring IP Mode (Static or DHCP)
To setup the SCP 2100 with a static IP address, use the following steps:
1. Press the
button (twice if the front
panel is in “Idle” mode).
2. Use the
and
buttons to
move the cursor to “Admin”, then press
the
button.
3. Use the
and
buttons to
move the cursor to “Unit Networking”,
then press the
button.
4. Use the
and
buttons to
move the cursor to “Network 1
Configuration”, then press the
button.
5. If unit is currently set to
“DHCP”, it can
be set to “Static” by pressing
to
navigate to the “Adapter Config 1”
Menu.
6. Press the
button to select “IP
Mode”. Use the
and
buttons
to highlight “Static”. Press the
button to apply the changes.
Main Menu ↔↕
>Admin
Active Errors
About System
Input: MPEG/IP 0.000 Mbps↔↕
Output: MPEG/IP 0.000 Mbps
Network 1: 0.0.0.0
Network 2: 0.0.0.0
Admin ↔↕
>Unit Networking
Profile
Unit Networking ↔↕
>Configure Networking
Network 1 Configuration
Network 2 Configuration
Press OK to configure ↔↕
IP Address: 0.0.0.0
Subnet Mask: 0.0.0.0
Gateway: 0.0.0.0
Mode: DHCP
Adapter Config 1 ↔↕
>IP Mode: DHCP
