SP LINK | Using SP LINK
104
|
Doc #OI0003 Part #004122 Rev 04 2010
When first setting up your SP PRO an initial estimation of the state of
charge must be programmed to enable the SP PRO to facilitate all the
functions that are determined by the state of charge measurement from
the first day. As the period of operation increases any small error from the
original estimation will be corrected.
The current status of the ExPANSION CARD is displayed. The SP PRO
can be set to use (Enabled) all the connected functions from the
expansion card like shunts and battery temperature sensor etc or to
ignore (Disabled) them. By default the Expansion Card is enabled.
If you are concerned that the standard passcode does not provide the
level of security you desire for changing settings, you can change the
passcode in your SP PRO to one that is uniquely yours.
Please note that if this passcode is lost or forgotten it can only be reset by
a procedure that requires someone to be on site.
If you require assistance resetting your passcode please consult your
Selectronic Accredited Installer.
To accurately measure and calculate inputs and outputs to and from the
batteries your SP PRO needs to start its measurements knowing what is
Zero. To set this parameter you must ensure all inputs and outputs are
switched off – that is no solar, wind or other inputs coming into the system
and all DC loads are switched off – then the ZERO SHUNT 1 and ZERO
SHUNT 2 buttons should be pressed.
The figures above the buttons indicate what the onboard computer in
your SP PRO perceives the relative current to be before zeroing.
If you are concerned that the default login password does not provide the
level of security for any access to the SP PRO, you can change the Login
Password in your SP PRO to one that is uniquely yours.
Like the passcode, if the Login Password is lost or forgotten it can only be
reset by a procedure that requires someone to be on site.
SP LINK will automatically update the Connection settings in Site
Information when you set your new Login Password.
